Table of Contents
Advertisement
THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector
(for roof vented or wall vented installation).
Not Actual Size (2 pieces must be assembled
as shown)
Two power cord clamp bushings - Actual Size
(for the cord hole in a metal upper cabinet).
Two 1/4" x 2" lag screws - Actual Size
(for wall stud holes).
Three 1/4" x 3" bolts - Actual Size
(for securing to the upper cabinet).
Four spring toggle heads - Actual Size
(for the toggle bolts).
NOTE: You need to install at least two lag screws into a 2" x 4" stud and four anchor bolts into the wall.
and the mounting area must meet the 150 lbs. weight requirement.
PARTS, TOOLS, MATERIALS
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord).
Actual Size
Four 1/4" x 3" toggle bolts - Actual Size
(for drywall holes).
Two tapping screws - Actual Size
(for attaching the damper duct connector)
One upper cabinet template
- Not Actual Size
One rear wall template - Not Actual Size
A.
A.
(3 pieces mounting plate only)
A.
A.
A.
A.
REAR WALL TEMPLATE
A.
12
12
12
12
F. CUT OUT FOR WALL
F. CUT OUT FOR WALL
F. CUT OUT FOR WALL
VENTED ONLY
F. CUT OUT FOR WALL
VENTED ONLY
12
VENTED ONLY
VENTED ONLY
B.
F. CUT OUT FOR WALL
B.
B.
B.
VENTED ONLY
12
REAR WALL TEMPLATE
B.
REAR WALL TEMPLATE
REAR WALL TEMPLATE
REAR WALL TEMPLATE
F. CUT OUT FOR WALL
VENTED ONLY
REAR WALL TEMPLATE
B.
12
F. CUT OUT FOR WALL
VENTED ONLY
B.
REAR WALL TEMPLATE
5
Hide quick links:
Advertisement
Table of Contents
