Parts, Tools, Materials - Kenmore 721.86012 Installation Instructions Manual

THE FOLLOWING PARTS ARE SUPPLIED WITH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector
(for roof vented or wall vented installation)
One power cord clamp bushing (for the cord hole in a metal upper cabinet)
Four 1/4" x 2" lag screws
(for wall stud holes)
Two 1/4" x 3" bolts
(for securing to the upper cabinet)
Four spring toggle heads
(for the toggle bolts)
One rear wall template
(3 pieces mounting plate only)
4
A.
A.
REAR WALL TEMPLATE
NOTE: You need to install at least one lag screw into a 2" x 4" stud and four anchor bolts into the wall,
A.
4
and the mounting area must meet the 150 lbs. weight requirement.
A.
A.
A.
A.
A.
A.
A.
12
12
F. CUT OUT FOR WALL
F. CUT OUT FOR WALL
4
VENTED ONLY
VENTED ONLY
B.
REAR WALL TEMPLATE
12
F. CUT OUT FOR WALL
4
VENTED ONLY
B.
12
F. CUT OUT FOR WALL
VENTED ONLY
REAR WALL TEMPLATE
12
12
12
B.
F. CUT OUT FOR WALL 12
F. CUT OUT FOR WALL
12
4
4 F. CUT OUT FOR WALL VENTED ONLY
VENTED ONLY
4 F. CUT OUT FOR WALL
F. CUT OUT FOR WALL VENTED ONLY
4 12
REAR WALL TEMPLATE 4 VENTED ONLY
VENTED ONLY B.
B.
F. CUT OUT FOR WALL
B.
4
B.
VENTED ONLY
B.
REAR WALL TEMPLATE
REAR WALL TEMPLATE
B.
REAR WALL TEMPLATE
REAR WALL TEMPLATE
REAR WALL TEMPLATE
REAR WALL TEMPLATE

PARTS, TOOLS, MATERIALS

One power cord clamp and
One dark-colored mounting screw
(to hold the power cord)
Four 1/4" x 3" toggle bolts
(for drywall holes)
Two tapping screws
(for attaching the damper duct connector)
One upper cabinet template
B.
5