Parts, Tools, Materials - Kenmore 721.85062 Installation Instructions Manual

PARTS, TOOLS, MATERIALS
THE FOLLOWING PARTS ARE SUPPLIED WiTH THE OVEN:
NOTE: Depending on your ventilation requirements, you may not use all of these parts.
Damper/duct connector
(for roof vented or wall vented installation).
Not Actual Size (2 pieces must be assembled
as shown)
One power cord clamp and
One dark-colored mounting screw
(to hold the power cord).
Actual Size
Two power cord clamp bushings - Actual Size
(for the cord hole in a metal upper cabinet).
Two 1/4" x 2" lag screws - Actual Size
(for wall stud holes).
Four 1//4'' x 3" toggle bolts - Actual Size
(for drywall holes).
Three 1/4" x 3" bolts - Actual Size
(for securing to the upper cabinet).
Four spring toggle heads - Actual Size
(for the toggle bolts).
Two tapping screws - Actual Size
(for attaching the damper duct connector)
One upper cabinet template
- Not Actual Size
One rear wall template - Not Actual Size
(3 pieces mounting plate only)
i
NOTE: You need to instaJJ at Jeast two Jag screws into a 2" x 4" stud and four anchor boJts into the wail
and the mounting area must meet the 150 Jbs. weight requirement.
5