Kenmore 721.85062 Installation Instructions Manual page 14

STEP 5 : INSTALL THE MOUNTING PLATE TO THE WALL
THE OVEN MUST BE CONNECTED TO
AT LEAST ONE WALL STUD
1. Draw a vertical line on the wall at the center of the
30" wide space. Use the mounting plate as the
template for the rear wall. Place the mounting plate
on the wall, making sure that the tabs are against
the bottom of the cabinet. Line up the notch and
center line on the mounting plate to the center line
on the wall.
2. While holding the mounting plate with one hand,
draw circles on the wall at holes "A", "B", "C"and
"D". Four holes must be used for mounting.
If the holes are not used, the installation will not
be secure. Installer must use these holes for proper
installation. Use toggle bolts through these holes
unless one of them lines up with a stud.
Use a wood screw for studs.
NOTE: Draw a fifth circle inside area "E", through
one of the holes to match the location of
astud. For wall vented: The oven requires a
rear wall cutout opening for the rear wall
duct and the exhaust adaptor must be
attached to the mounting plate.
See the next page on how to prepare the
rear wall cutout opening and the exhaust
adaptor/mounting plate for wall vented.
3. Drill holes through the circles. If there is a stud, drill
a 3/16" hole for lag screws. If there is no stud, drill
a 5/8" hole for toggle bolts. Make sure to use at
least 1 lag screw at holes of area "E" in a stud,
and 4 toggle bolts at in the drywall or the plaster.
4. Attach the plate to the wall. To use spring toggle
head bolts: Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate and replace
the spring toggle heads to 3/4" past the bolt ends.
Insert the spring toggle heads into the holes in the
wall to mount the plate. You may pull forward
on the bracket to help in tightening the toggle bolts.
Tighten all bolts.
Mounting Plate
Figure 29
14
Space More Than Wall Thickness
Toggle Wings
Toggle Bolt
Bolt End
Wall
3/16" Hole on Studs
3/4" Hole on Dry wall Only
Minimum 66"
From the Floor
Vented Only
Draw Lines
on Studs
Mounting Plate
Center Line
A
Center Line
C
E
Support Tab
1 piece mounting plate
3/16" Hole on Studs
3/4" Hole on Dry wall Only
Minimum 66"
From the Floor
Vented Only
Draw Lines
on Studs
Center Line
A
Mounting Plate
C Center Line
E
Support Tab
3 pieces mounting plate
Figure 28
For Wall-
Draw
B
D
Support Tab
For Wall-
Draw
B
D
Support Tab