Step 3 : Prepare The Venting Blower; Roof-Vented Installation - Kenmore 721.85062 Installation Instructions Manual

Hide thumbs Also See for 721.85062:

Installation instructions manual (21 pages)

Table Of Contents

Table of Contents

4. Reassemble the blower wire. See Figure 15.

5. Rotate the unit so that the exhaust ports face the rear of the cabinet. See Figure 17.

When you insert blower unit, blower wire must be like F�gure 16.

6. Place blower unit back into cabinet. Check that the exhaust ports face towards the rear of the cabinet.

See Figure17.

7. Reattach the blower plate to cabinet so the exhaust ports and blower plate opening are aligned.

Attach with one blower unit mounting screw and then one blower plate mounting screw. See Figure 18.

Figure 15

Roof-Vented Installation:

1. Remove one blower unit mounting screw and one

or two blower plate screw(s). Remove the blower

plate from cabinet. See Figure 19.

2. Use side cutter or thin snips to cut and remove

knockouts "A" from Blower plate. Discard

knockouts. Be careful not to distort the plate.

See Figure 20.

3. Carefully lift the blower unit out of the microwave

oven.

4. Rotate blower unit 90°so the exhaust ports face

the top of the cabinet. See Figure 21.

5. Reassemble the blower wire.

6. Place blower unit back into microwave oven.

7. Reattach blower plate to microwave oven. Attach

with the one blower unit mounting screw and then

the one or two blower plate mounting screw(s).

See Figure 22.

8. Attach the exhaust adapter to the blower plate

by sliding it into the Guide. See Figure 23.

Blower unit

Figure 21