To Edit A Custom Configuration; To Add A Vlan-Enabled Port Set And Vlan Subnet - HP StoreOnce 2700 Installation And Configuration Manual

3. Repeat until all the Subnets for the selected Port Set have been defined.
Each physical Port Set may be configured with one Subnet that uses the IPv4 protocol
and one Subnet that uses the IPv6 protocol.
If the Port Set is VLAN enabled, it is possible to add a total of 128 VLAN Subnets. These
total values apply across the whole network configuration, not per Port Set.
If DHCP is used , one IPv4 and one IPv6 subnet will be consumed.
4. Click Save to save all configuration details.
Step 4 and 5: Validation and Activation
1. Click Validate to validate the network configuration. If there are any errors, the error message
will guide you to the parts of the configuration that need correcting. Make the necessary
changes, save them and click Validate again.
2. If validation is successful, you have two choices. The StoreOnce GUI will prompt you to activate
the new configuration immediately. Or you can save it and activate it separately from the
Network Configuration — Custom page.
NOTE:

To edit a custom configuration

You cannot edit the current or the Factory_Default_Configuration. However, you can
edit any configuration in the Custom configuration list. if the StoreOnce CLI wizard was used to
configure the network at installation, there will be at least one custom configuration in the list,
net_wizard.
NOTE: Before activating an edited custom configuration, you may like to create a copy of the
current configuration and save it to a different name. Once current is overwritten it cannot be
restored.
1. Select the configuration that you wish to edit and click Edit.
2. Make changes to the editable fields, as appropriate, and click Save. Some examples are
described below.
To add a VLAN–enabled Port Set and VLAN Subnet
NOTE: This is only applicable for StoreOnce VSA VMware users. It is not applicable for Hyper-V
and KVM VSAs.
1. Select the configuration in the Custom Network Configuration list and click Edit.
It is not possible to activate a new configuration if storage addition is in progress.
To edit a custom configuration 57