HP StoreOnce 2700 Installation And Configuration Manual page 55

Table 6 Network Configuration Port Set fields
Field name
Port Set Name
Ports
Bond mode
VLAN Tagging Enable
3. If multiple ports are selected, the Bond Mode selection will be active.
If required, check the VLAN Tagging Enable box and click OK.
NOTE: VLAN tagging is not supported with Bonding Mode 6.
4. At this point you may choose to define the Subnets for the Port Set or to create additional Port
Sets by clicking on Add in the Port set section. For the purposes of this example, we shall
continue to Subnet configuration.
TIP: It is good practice to Save the network configuration at regular intervals.
Description
The name of the Port Set
The ports that have been defined for use by the Port Set
and their speed..
Any bond mode that has been defined. Bond modes
are only appropriate if there is more than one port in
the Port Set.
This defines whether the Port Set is VLAN enabled or
not.
To add a custom configuration 55