Network Configuration Guidelines - HP StoreOnce 2700 Installation And Configuration Manual

Figure 22 Network example

Network configuration guidelines

For installations where you are not installing on a DHCP network it is necessary to use the StoreOnce
CLI wizard command sequence, net set wizard, to set up the basic network configuration
that gives you access to the StoreOnce GUI. The StoreOnce GUI or StoreOnce CLI may then be
used to refine the network configuration.
For more complex configurations, a major benefit of using the StoreOnce GUI is that the
configuration can be saved at any point in the network configuration process. See the appropriate
HP StoreOnce Installation and Configuration guide for your product for examples of using the
StoreOnce CLI to configure the network.See the HP StoreOnce CLI Reference guide for examples
of using the StoreOnce CLI to refine the network configuration.
:
If you are installing on a DHCP network and you connect to LAN port 1, you do not need to use
the StoreOnce CLI wizard command sequence. A basic network configuration is created
automatically for you, which gives you immediate access to the StoreOnce GUI. You can then use
the StoreOnce GUI pages to refine the network configuration.
When working with network configurations the following guidelines apply:
There may be up to 16 configurations on any StoreOnce Backup system, but only one can
be active.
There are two fixed configurations reserved for the system that cannot be modified:
Factory_Default_Configuration and current.
Configuration names are alpha numeric.
Network configuration guidelines 35