HP StoreOnce 2700 Installation And Configuration Manual page 46

Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->2
<--DHCP/Static: Static
Enter an IP address for this network:
-->172.1.1.16
<--Static IP address: 172.1.1.16
Enter network mask or network prefix length :
For IPv4 networks, you may enter either a netmask or a length;
For IPv6 networks, you must enter a network prefix length.
-->255.255.0.0
<--Network mask/length: 255.255.0.0
-----------------------------------------------------
Note that if you intend to select this network as the
default network later on, then you must now specify
an IP address.
If, on the other hand, you do not intend to have a
default network, then you may not specify any
gateways for the system.
-----------------------------------------------------
Enter gateway IP address :
-->172.1.1.1
<--Gateway: 172.1.1.1
Enter domain name :
-->uk.mycompany.net
<--Domain name: uk.mycompany.net
----------------------
Network: subnet_4
----------------------
IP Addresses: 172.1.1.16
Netmask/Prefix: 255.255.0.0
Domain Name: uk.mycompany.net
Gateway: 172.1.1.1
VLAN tag:
Port Set: Port Set_3 with these interfaces: eth2 eth3
Encryption Links:
Bonding Mode: 6 (Active Load Balance Bonding)
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Configuration okay: Yes
4. You have now configured all available ports. The wizard now asks you to confirm your settings
and will validate and automatically activate this configuration for you if you confirm the settings
are correct and there are no errors.
-------------------------------------------------------------
If you have added all subnets, then you may proceed: you will
then be shown a summary of the configuration and be given the
option to validate it, and then a further option to apply it.
Otherwise, you may continue to add further subnets.
-------------------------------------------------------------
Do you want to configure another subnet?
1 = No (default)
2 = Yes - on a new physical port set
3 = Yes - a new IP6 subnet same physical port set
-->1
<--Another subnet: No
---------------------------------------------------------------------
If you specify at least one network gateway, you must choose a
default network from either the defined DCHP OR Static subnets
as DCHP includes both IPv4 and IPv6 gateways.
The default network must have an associated gateway.
If you do not specify any network gateways, then you may not choose
a default network.
---------------------------------------------------------------------
Select default from Static or DHCP subnets :
1 = DHCP (default)
2 = Static
-->1
<--DHCP/Static: DHCP
46 Network configuration, how to use StoreOnce CLI commands