Configure Licenses; Verify Hardware Health; Finish Configuration (And Reboot) - HP StoreOnce 2700 Installation And Configuration Manual

Backup system
Table of Contents

Advertisement

Configure Licenses

The customer must provide license information if this step is to be executed.
You may skip this step and the customer may configure licenses later, if the required License To
Use (LTU), for example for replication, have not yet been obtained. See
licenses (page

Verify Hardware health

This step generates a file called HealthReport<timestamp> in the health folder of the
StoreOnce folder structure, which you can copy after installation as a record of system health. This
file may be accesed over SFTP and contains status information on hardware, filesystem and service
set. For more information about accessing StoreOnce folders and the files in them, see
the StoreOnce Backup system over SFTP (page

Finish Configuration (and reboot)

Choose either Finish Configuration and reboot or Finish Configuration. If you have reset the time
of the HP StoreOnce Backup system so that it has moved backwards, the configuration must be
completed with a reboot.
This performs a couple of tasks:
Save the configuration details
Two configurations, devconfig<timestamp>.txt containing network and other device
management settings and devconfig<timestamp>.zip containing backup targets, email
settings, user accounts and so on are saved in the config folder. But at installation they
contain only the settings that have been configured during installation. It is strongly
recommended to use StoreOnce CLI commands to save the configuration again after backup
targets, email settings, user accounts and so on, have been configured, as described in
configuration file (page
Collect a support ticket
This can take up to 20 minutes to complete because it is saving a record of the initial setup
and you will not be able to use the StoreOnce CLI during this period, although the StoreOnce
GUI will still be accessible.
If you choose the reboot option (recommended), the HP StoreOnce Backup system will then reboot.
60),
74).
63).
System configuration using system set config command
Configuring
Accessing
Saving
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents