Connecting The Slave Renderer To A Lustre Workstation - IBM Z PRO 6223 Hardware Setup Manual

To connect the tablet:
Connect the tablet to the serial or USB port of the station, depending on the model you are
using.
You may extend this serial or USB connection using the cable extension provided in the
DL.CAB-500 cable kit and labeled as DL.CAB-23A.
N :
You may need to restart Windows for the tablet to be recognized. If using the Linux
OTE
version of Lustre, starting Xserver will prompt tablet recognition. Press
to start the Xserver.

Connecting the Slave Renderer to a Lustre Workstation

The Slave Renderer is available for the Master Station, the Lustre Station, and the Lustre HD
Station. Although the Slave Renderer is connected using a network connection, a higher
Category 6 grade cable is needed to accommodate the data that is transmitted.
For information on configuring the IP addresses of the network ports that connect the two
workstations, see the Autodesk Lustre 2008 Software Installation Guide for your operating
system.
N :
The illustration in this procedure contains a comprehensive IBM IntelliStation Z Pro 6223
OTE
backplane, since the on-board network port is in the same location independent of the platform
running on the workstation.
To connect the Slave Renderer:
Connect the Category 6 crossover cable to the on-board network port at the back of the
1.
Lustre workstation.
Connect the other end of the cable to the 1000Base-T port 1 of the Slave Renderer machine.
2.
Connecting the Slave Renderer to a Lustre Workstation
C +A +
TRL LT BACKSPACE
33