Connecting System Components; Summary; Workflow For Connecting System Components In The Lustre Workgroup - IBM Z PRO 6223 Hardware Setup Manual

Summary

Workflow for Connecting System Components in the Lustre Workgroup

Connecting the Autodesk Control Surface
Assigning an IP Address to the Autodesk Control Surface
Configuring Lustre to Connect to the Autodesk Control Surface
Connecting the Tangent CP100 Control Surface
Connecting a Stand-Alone Tablet
Connecting the Slave Renderer to a Lustre Workstation
Connecting Video I/O to a Master or HD Station
Connecting to a High-Speed Data Link Device (HSDL)
Workflow for Connecting System Components in the Lustre
Workgroup
After you have connected peripherals to each Lustre workstation in your workgroup, you are
ready to connect them to a control surface, to video I/O hardware, and to a Slave Renderer.
See the following table for a summary of the steps necessary to connect components in your
workgroup.

Connecting System Components

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
. . . . 25
. . . . . . . . . . . . . . . . . . . 28
. . . . . . . . . . . . 31
. . . . . . . . . . . . . . . . . . . . . . . . . . . 31
. . . . . . . . . . . . . . . . . . . . 33
. . . . . . . . . . . . . . . . . . . . . . . . . . . 34
. . . . . . . . . . . . . . . . . . . . . 43
25