Connecting The Autodesk Control Surface - IBM Z PRO 6223 Hardware Setup Manual

3 Connecting System Components
Step:
1. Connect the control surface to your workstation.
2. If necessary, connect a tablet to your workstation.
3. Connect a Slave Renderer to the Lustre workstation.
4. Connect the workstation to video I/O components.
5. Connect the workstation to a high-speed data link
device.

Connecting the Autodesk Control Surface

The Autodesk control surface consists of three panels. You can use any combination of one or
all of the panels.
If you will use more than one panel of the control surface, you must use the four port network
switch to cross-connect all of the panels.
N :
The illustrations in this procedure contain a comprehensive IBM IntelliStation Z Pro 6223
OTE
backplane, since the Broadcom network card is in the same location independent of the platform
running on the workstation. The illustrations also show the colour grading panel. The colour
grading panel is the only one that has a USB connection for the integrated tablet.
26
Refer to:
For the Autodesk control surface:
"Connecting the Autodesk Control
Surface" on page 26, "Assigning an
IP Address to the Autodesk Control
Surface" on page 28, and
"Configuring Lustre to Connect to
the Autodesk Control Surface"
page 31.
For the Tangent CP100 control
surface: "Connecting the Tangent
CP100 Control Surface" on page 31.
"Connecting a Stand-Alone Tablet"
on page 32.
"Connecting the Slave Renderer to
a Lustre Workstation" on page 33.
"Connecting Video I/O to a Master
or HD Station" on page 34.
"Connecting to a High-Speed Data
Link Device (HSDL)" on page 43.
on