IBM Z PRO 6223 Hardware Setup Manual page 11

Verifying System BIOS Version and Settings
There are two models of the IBM Z Pro 6223. Model 64U was the first shipped for Incinerator
systems. This model was replaced by the 7DU when the Restriction of Hazardous Substances
(RoHS) European Union directive took effect.
•
The current certified system BIOS version for the 64U model is 1.52A.
•
The current certified system BIOS version for the 7DU model is 1.66A.
If the IBM workstation is using a different BIOS version, you must update it for this release.
Instructions for updating the BIOS on your IBM 6223 workstation are provided in articles
available on the IBM Web site.
For the 64U model, refer to:
http://www-307.ibm.com/pc/support/site.wss/document.do?sitestyle=ibm&lndocid=MIGR-
56667
For the 7DU model, refer to:
http://www-304.ibm.com/jct01004c/systems/support/supportsite.wss/
docdisplay?lndocid=MIGR-57658&brandind=5000004
N :
You do not normally need to adjust these settings. BIOS settings for the workstation are
OTE
provided here for informational purposes only.
To enter the system BIOS, you must press F1 while booting the workstation.
The following table lists the proper Autodesk certified BIOS settings. Items not listed are set to
their default factory settings.
BIOS Menu
Devices and I/O ports
Startup Options, Startup
Sequence Options, Primary
Startup Sequence
Startup Options, Startup
Sequence
Startup Options
Item
Parallel Port
Serial ATA
First Startup Device
Second Startup Device
Third Startup Device
Fourth Startup Device
Wake on LAN
Planar PXE/DHCP Priority
PCI Device Boot Priority
Hardware Configuration Guidelines
Value
Disabled
Disabled
Removable
Hard Disk
CD/DVDROM
Disabled
Off
Normal
SLOT 1
7