Assembling The Sparkling Beverage Maker; Installing The Sodastream Co 2 Carbonator - KitchenAid KSS1121 Instruction Manual

ASSEMBLING THE SPARKLING BEVERAGE MAKER

Installing the SodaStr_eam CO
Befor_e Fir_st Use
Place the Sparkling Beverage Maker on a
flat, sturdy surface, in an upright position.
Remove packaging materials.
The Sparkling Beverage Maker uses 3 AAA
batteries (preinstalled). To replace batteries,
see the "Care and Cleaning" section.
Remove seal and cap from SodaStream
2
CO Carbonator. Insert 60 L*
2
SodaStream CO
Sparkling Beverage Maker. First tip
downward into the base and then
push upward into the valve fitting.
To reinstall back cover: tilt back cover
4
toward you; insert bottom tab into slot
and push cover into place.
* The 60 L
SodaStream
on the level of carbonation.
8
Carbonator into the
2
Carbonator produces up to 60 liters of sparkling water, depending
Car_bonator_
2
To remove back cover: Grasp back
1
cover and pull away from unit. Set
cover aside.
Turn the SodaStream CO
3
counterclockwise until it stops.
Hand-tighten only.
Carbonator
2