Table of Contents
Advertisement
ASSEMBLING THE SPARKLING BEVERAGE MAKER
Installing the SodaStream CO
Before First Use
Place the Sparkling Beverage Maker on a
flat, sturdy surface, in an upright position.
Remove packaging materials.
The Sparkling Beverage Maker uses
3 AAA batteries. To replace batteries,
see the "Care and Cleaning" section.
Remove seal and cap from SodaStream
2
CO
Cylinder. Insert 60 L* SodaStream
2
CO
Cylinder into the Sparkling
2
Beverage Maker. First tip downward
into the base and then push upward
into the valve fitting.
To reinstall back cover: tilt back cover
4
toward you; insert bottom tab into slot
and push cover into place.
* The 60 L
SodaStream
on the level of carbonation.
10
W10624164A_EN_v05.indd 10
Cylinder
2
Cylinder produces up to 60 litres of sparkling water, depending
To remove back cover: Grasp back
1
cover and pull away from unit. Set
cover aside.
Turn the SodaStream CO
3
counterclockwise until it stops.
Hand-tighten only.
Cylinder
2
6/3/14 3:51 PM
Advertisement
Table of Contents
