Types Of Wood; Get Ready To Build; Die-Cut Patterns - GREAT PLANES Piper j-3 cub Instruction Manual

TYPES OF WOOD

GET READY TO BUILD

1. Unroll the plan sheet. Re-roll it inside out to make it lie flat.
2. Remove all parts from the box. As you do, figure out the
name of each part by comparing it with the plans and the
parts list included with this kit. Using a felt-tip or ballpoint
pen, lightly write the part name or size on each piece to
avoid confusion later. Use the die-cut drawings shown on
page 7 to identify the die-cut parts and mark them before
removing them from the sheet. Save all scraps. If any of
the die-cut parts are difficult to punch out, do not force
them! Instead, cut around the parts with a hobby knife. After
punching out the die-cut parts, use your Bar Sander or
sanding block to lightly sand the edges to remove any die-
cutting irregularities or slivers.
DIE-CUT DRAWINGS
6