Table of Contents
Advertisement
Types of Wood
GET READY TO BUILD
❏
1. Unroll the plan sheets. Roll the plan sheets inside out
to make them lie flat.
❏
2. Remove all the parts from the box. As you do,
determine the name of each part by comparing it with the
plan and the parts list. Use a ballpoint pen (not a felt-tip pen)
to lightly write the name or size on each piece so you can
identify it later. Use the die-cut patterns on pages 6 & 7 to
identify and mark the die-cut parts before you remove them
from their die sheets. Many of the parts already have
numbers stamped on them, but in some cases the numbers
are located alongside the parts or only on the die drawings
in the manual. You may remove all the die-cut parts from
1/64" = .4mm
1/32" = .8mm
1/16" = 1.6mm
3/32" = 2.4mm
1/8" = 3.2mm
5/32" = 4mm
Inch Scale
0"
1"
0
10
20
30
Metric Scale
Metric Conversions
3/16" = 4.8mm
1/4" = 6.4mm
3/8" = 9.5mm
1/2" = 12.7mm
5/8" = 15.9mm
3/4" = 19mm
To convert inches to millimeters, multiply inches by 25.4
2"
3"
40
50
60
70
their die sheets now or wait until you need them. If a part is
difficult to remove, don't force it out but cut around it with a
hobby knife and a #11 blade. After you remove the parts
from their die sheets, lightly sand the edges to remove
slivers or die-cutting irregularities. Save some of the larger
scraps of wood.
❏
3. As you identify and mark the parts, separate them into
groups, such as fuse (fuselage), wing, and tail.
1" = 25.4mm
2" = 50.8mm
3" = 76.2mm
6" = 152.4mm
12" = 304.8mm
15" = 381mm
4"
80
90
100 110 120 130 140 150 160 170 180
5
18" = 457.2mm
21" = 533.4mm
24" = 609.6mm
30" = 762mm
36" = 914.4mm
5"
6"
7"
Advertisement
Table of Contents
