Table of Contents
Advertisement
3.2.4 USB Configuration Sub-Menu
You can use this screen to view the USB Configuration Menu. Use the up and
down arrow (/) keys to select an item. Use the Plus and Minus (+/-) keys to
change the value of the selected option. The settings are described on the following
pages.
Main
Advanced
USB Configuration
Module Version – x.xx.x – xx.x
USB Devices Enabled:
1 Drive
Legacy USB Support
Port 64/60 Emulation
USB 2.0 Controller Mode
BIOS EHCI Hand-Off
Hotplug USB FDD Support
USB Mass Storage Device Configuration
Feature
USB Configuration
Legacy USB Support
Port 64/60 Emulation
USB 2.0 Controller Mode
BIOS EHCI Hand-Off
Hotplug USB FDD Support
BIOS Setup Utility
PCI/PnP
Boot
[Enabled]
Option
Disabled
Auto
Enabled
Enabled
Disabled
Hi Speed
Full Speed
Enabled
Disabled
Enabled
Disabled
Auto
44
http://www.tyan.com
Security
Chipset
Enables support for
legacy USB. AUTO
option disables legacy
support if no USB
devices are
connected.
← → Select Screen
↑↓ Select Item
+/-
Change Option
F1
General Help
F10 Save and Exit
ESC Exit
Description
Enables support for legacy
USB. AUTO option disables
legacy support if no USB
devices are connected.
This feature allows you to
enable emulation of I/O ports
64h and 60h so that there is full
PS/2 legacy support for USB
keyboards and mice.
Configure the USB 2.0
controller in Hi Speed (480
Mbps) or Full Speed (12Mbps).
This is a work around for OSes
without EHCI hand-off support.
The EHCI ownership change
should claim by EHCI driver.
Enable or disable hotplug USB
floppy support
Exit
Advertisement
Table of Contents
