Table of Contents
Advertisement
1. Cable Ends: Inspect end fittings daily for wear. Replace cables at the first sign of wear or on an
annual basis. If the cable tension has been adjusted, be certain that the cable nut is tight.
2. Nuts, Bolts, and Fasteners: Check tightness weekly. If any hardware has become loose, retighten
and/or use Loctite
3. Frames: Wipe all machines down with a damp cloth and dry completely each day. This includes
painted parts, chrome parts and upholstered pads.
4. Painted and chrome plated parts: Use Simple Green or similar cleaner for light dirt and grime. Use
Turtle Wax Polishing Compound or a good car polish to remove heavier dirt and grease as well as
for polishing. DO NOT use solvents, lacquer thinner, acetone or finger nail polish remover. For
scuffs and marks that are not removed by the above methods use a soft scrub cleanser. Make
sure all parts are dry upon completion.
5. Weight stack enclosures (shrouds): Wipe down with a damp cloth as needed.
6. Exercise instruction labels: Clean with soap and water as needed.
7. Guide rods: Wipe all dirt and dust from the guide rods before applying a light application of Tri-
TM
Flow
or other teflon spray lubricant. Spray the Tri-Flow
with the rag. DO NOT use oil lubricants such as WD-40. Caution: Tri-Flow
clothing.
8. Bronze bushings: Check monthly for signs of wear and replace as needed. Lubricate monthly with
TM
Tri-Flow
9. Please refer to the General Maintenance Manual (part number: AM-GMM) for other important
safety and maintenance information.
10. Be sure all hardware is tight before using the machine.
11. Use only Paramount supplied components when servicing your machines. Be certain to replace
any components at the first signs of wear.
12. DO NOT install any fitness equipment near a pool, hot tub or other damp locations. Corrosion
!
caused by installation in these locations can lead to premature failure of components.
After you have unpacked and inventoried all of the components, read through the
!
remainder of the assembly instructions to familiarize yourself with the assembly
procedure!
Each step will require the components shown in the table associated with the step.
Read the instructions for each step before assembling.
TM
brand Threadlocker 242.
.
G
C
ENERAL
ARE AND
TM
5
M
AINTENANCE
on a rag and then wipe the guide rods
TM
will stain carpet and
Advertisement
Table of Contents
