Eneral Are And; Aintenance - Paramount Fitness FS-55 Pec Fly/Rear Delt Assembly Manual

Table of Contents

1. Cable Ends: Inspect end fittings daily for wear. Replace cables at the first sign of wear or on an

annual basis. If the cable tension has been adjusted, be certain that the cable nut is tight.

2. Nuts, Bolts, and Fasteners: Check tightness weekly. If any hardware has become loose, retighten

and/or use Loctite

3. Frames: Wipe all machines down with a damp cloth and dry completely each day. This includes

painted parts, chrome parts and upholstered pads.

4. Painted and chrome plated parts: Use Simple Green or similar cleaner for light dirt and grime. Use

Turtle Wax Polishing Compound or a good car polish to remove heavier dirt and grease as well as

for polishing. DO NOT use solvents, lacquer thinner, acetone or finger nail polish remover. For

scuffs and marks that are not removed by the above methods use a soft scrub cleanser. Make

sure all parts are dry upon completion.

5. Weight stack enclosures (shrouds): Wipe down with a damp cloth as needed.

6. Exercise instruction labels: Clean with soap and water as needed.

7. Guide rods: Wipe all dirt and dust from the guide rods before applying a light application of Tri-

Flow

or other teflon spray lubricant. Spray the Tri-Flow

with the rag. DO NOT use oil lubricants such as WD-40. Caution: Tri-Flow

clothing.

8. Bronze bushings: Check monthly for signs of wear and replace as needed. Lubricate monthly with

Tri-Flow

9. Please refer to the General Maintenance Manual (part number: AM-GMM) for other important

safety and maintenance information.

10. Hardware and components are indicated with a balloon. Refer to the hardware tables that

accompany each step for corresponding size and type.

11. Be sure all hardware is tight before using the machine.

DO NOT install any fitness equipment near a pool, hot tub or other damp locations. Corrosion

caused by installation in these locations can lead to premature failure of components.

After you have unpacked and inventoried all of the components, read through the

remainder of the assembly instructions to familiarize yourself with the assembly

procedure!

Each step will require the components shown in the table associated with the step.

Read the instructions for each step before assembling.

ENERAL

brand Threadlocker 242.

ARE AND

on a rag and then wipe the guide rods

will stain carpet and

Table of Contents