Using Setup Mode To Review Printer Settings; Accessing The Printer Settings - Kodak 6800 User Manual

Operating the Printer

Using Setup Mode to Review Printer Settings

Accessing the Printer
Settings
Printer Setting Operator Panel
Display
Printer ready Ready
Making a test print Test Print Mode
Check remaining Remain = XXX/YYY
paper status
Checking the ribbon DonorRemain = XX[%]
status
Checking the printer Printed = XXXXX
total print count
Checking the printer Main Firm =
firmware version
Checking the image DSP Firm =
processing firmware
version
4-2
Use the operator panel to review printer settings in Setup mode.
Printer settings
are displayed here
Kodak
Photo Printer 6800
Power
Ready
Error
1. Press Menu to enter Setup Mode.
2. Press Menu repeatedly to scroll
through the printer settings.
3. Press +/- to scroll through selections.
Press Menu repeatedly to scroll through the printer settings in the following
order.
Action Required
None. The printer is on and ready to make prints.
Press enter to make a test print. See
page 1-10.
None. XXX represents how many remaining prints you can make
with the current paper roll. YYY represents the total number of
prints on a paper roll. The counter is reset each time you press
Paper Rewind.
None. XX[%] represents the percentage of the installed ribbon that
is available for making prints.
None. XXXXX represents the total number of prints made since the
printer was manufactured. This counter cannot be reset.
None. The printer control firmware version number is displayed.
None. The image processing firmware version is displayed.
1,2
3
Paper
Menu Advance
Enter Paper
5
Rewind/Clear
4
4. Press Enter to initiate an action
or accept a change.
5. Press Clear to exit Setup Mode.
"Making a Test Print" on