Kodak 6800 User Manual page 14

Setting Up the Printer
Supply spool
Notches
Lugs
Thumb wheel
Take-up spool
1-6
Push the bar code end of the supply spool into the spool holder on the
4.
right.
Place the left side of the supply spool into the spool holder on the left.
5.
Bar code
Rotate the thumb wheel until the lugs on the spool holder lock into the
6.
notches on the supply spool.
Remove the label and wrapper from the ribbon.
7.
Label
Push the right side of the take-up spool into the spool holder on the
8.
right.
Place the left side of the take-up spool into the spool holder on the left.
9.
Adjust the take-up spool until the lugs on the spool holder lock into the
10.
notches on take-up spool.
If there is any slack in the ribbon, remove it by turning the supply spool.
11.
IMPORTANT:
Slack in the ribbon can cause a paper jam when making
prints.