Kodak 6800 User Manual page 33

Error Message
Cannot open the USB port.
Please check the printer
cables and power.
Cannot access the file or read
the data.
Parameter error, such as
undefined tag or insufficient
data.
The printer with the selected
ID number cannot be found.
The printer is not ready.
The printer is busy.
The ribbon is advancing.
The operator panel is in use.
Description or Cause
The software is unable to
communicate with the printer.
A file required by the calibration
software is missing or corrupt.
An internal error has occurred within
the calibration software.
The calibration software is unable to
find the printer with the selected
Printer ID.
The printer is not ready for
calibration.
The printer is not ready for
calibration.
The printer is not ready for
calibration.
The printer is not ready for
calibration.
Calibrating the Printer
Possible Solution
• Check that the printer cables are secure.
• Check that the printer is turned on and the
operator panel Ready light is illuminated.
• Power the printer off then on.
• Reboot your computer.
Uninstall then reinstall the calibration
software. See "Installing the Calibration
Software" on page 3-1.
• Close the calibration software and try
calibrating the printer again.
• Uninstall then reinstall the calibration
software. See "Installing the Calibration
Software" on page 3-1.
• Check the KODAK web site for an updated
version of the calibration software.
• Close the calibration software.
• Check that the printer cables are secure.
• Check that the printer is turned on and the
operator panel Ready light is illuminated.
• Run the calibration software and try
choosing the printer again.
• Check that the printer cables are secure.
• Check that the printer is turned on and the
operator panel Ready light is illuminated.
• Wait a few minutes until the operator
panel Ready light is illuminated.
• If this message continues to occur, power
the printer off and then on.
• Wait a few minutes until the operator
panel Ready light is illuminated.
• If this message continues to occur, power
the printer off and then on.
• Wait a few minutes until the operator
panel Ready light is illuminated.
• If this message continues to occur, power
the printer off and then on.
3-9