To Open/Close Shield; To Operate Browvents; To Operate Top Vents - Arai Open Face Series Instructions For Use Manual

OPEN CLOSE
CLOSE
CLOSE
OPEN
FRONT
FRONT
OPEN CLOSE
CLOSE
OPEN
English

TO OPEN/CLOSE SHIELD

Pull outward on lower left side of shield to release latch system and then raise
the shield. To close the shield, push down the shield until the shield is fully
latched
WARNING:
If your shield becomes too scratched or uncleanable, replace it with a
new one. Impaired visibility causes accidents. Use a solution of mild
soap or detergent and lukewarm water to clean your shield. Rinse
well with clean water, and wipe off with a soft cloth. Never use petrol,
thinner, benzene or any other solvents. There are many "aggressive"
cleaners on the market, including some supposed to be specifically for
use on shield. Arai strongly recommends that you do not use any such
products to clean your shield as some of their ingredients may have
damaging effects on the shield and other plastic parts installed on your
helmet. Do not apply stickers or adhesive tape to the shield, as this will
weaken the hard coating. If tinted, the shield is for daylight use only.

TO OPERATE BROWVENTS

The Browvents are operated from fully closed through intermediate, to
fully open positions by simply pulling the vent control down to open,
pushing up to close.

TO OPERATE TOP VENTS

Simply push the switches/levers on each vent to open/close the vents.
OPEN