To Open/Close Shield; To Operate Demist System - Arai RX-7GP Manual

4
English

TO OPEN/CLOSE SHIELD

Pull the shield latch tab on lower left side of the shield outward to release
latch system and then raise the shield. To close the shield, push down the
shield until the shield latch tab fully latches into place.
Apply one or two drops of supplied silicone lubricant around the edge trim
and on other moving parts and wipe off with soft tissue paper to maintain
proper operation.
WARNING:
If your shield becomes too scratched or uncleanable, replace it with a
new one. Impaired visibility causes accidents. Use a solution of mild
soap or detergent and lukewarm water to clean your shield. Rinse
well with clean water, and wipe off with a soft cloth. Never use petrol,
thinner, benzene or any other solvents. There are many "aggressive"
cleaners on the market, including some supposed to be specifically for
use on shield. Arai strongly recommends that you do not use any such
products to clean your shield as some of their ingredients may have
damaging effects on the shield and other plastic parts installed on your
helmet. Do not apply stickers or adhesive tape to the shield, as this will
weaken the hard coating. If tinted, the shield is for daylight use only.

TO OPERATE DEMIST SYSTEM

Demist system is incorporated in the shield latch system to allow more
rapid cleaning on any interior mist with the shield remaining latched in
place. Simply push the shield latch tab firmly forward to accomplish the
small gap that will assist moisture dispersal.