Use Of Extension Cards; Extension Card For Digital Clocks; Mobaline Extension Cards - WEMPE 20097 Operating Instructions Manual

WEMPE digital main clock 20097
Operation
6. Set this time in the analogue time setting menu of the main clock with the keys 8 and
9 .
7. Press the ENTER key for confirmation.
8. Press the MENUE key. The secondary clocks are synchronised automatically. The
main clock and the connected secondary clocks are now set to an standardised time.
9. Press the MENUE key again to return to the time display.

1.4 Use of extension cards

The main clock detects automatically that extension cards are inserted in the slots. Inserted
extension cards are automatically initialised and set-up according to their basic functions.
The extension card settings are also protected by the system's password.
Depending on the used slot, the number 2 – 4 is indicated after the term "Module".

1.1.1 Extension card for digital clocks

An extension card for digital clocks needs to be installed to operate digital secondary clocks.
Both times (UTC and LT) are always transmitted via the BCD code.
The standard display of digital WEMPE secondary clocks is LT. The display can be changed
from LT to UTC manually by means of an internal jumper.
To change from the UTC date transmitted by default setting to the LT date, proceed as
follows:
1. Remove write protection (
2. Press the key 1 several times until
the message on the right appears on
the display:
3. Press the ENTER key for confirmation. The cursor starts flashing.
4. Press the key 2 to select UTC or LT date.
5. Press the ENTER key to confirm the modification.
To cancel the modification, press the MENUE key twice.
6. Press the MENUE key to return to the time display.

1.1.2 MOBALine extension cards

If a MOBALine extension card for automatically adjusting secondary clocks is installed in the
unit, it is not necessary to carry out any settings for the secondary clocks.
28
1.1.1).
V3.0 01/2011