Console Mounting; Fitting Of Cables; Fitting Of Cables At The Wall-Mounting Version - WEMPE 20097 Operating Instructions Manual

WEMPE digital main clock 20097
Installation and putting into operation

1.1.2 Console mounting

1. Prepare the switchboard cut-out
according to the illustration.
NOTICE!
Size the drill hole diameter for M4
thread screws.
2. Insert the main clock from above into the switchboard cut-out.
3. Place M4 thread screws from above into the edges of the main clock and fit them
tightly from the backside of the switchboard with washers and nuts.
4. Make sure that the main clock holds reliably and safely on the console.

1.4 Fitting of cables

1.1.1 Fitting of cables at the wall-mounting version

1. Unscrew both screws of the main clock's terminal box cover and remove the cover.
2. Pierce a pre-cut hole for the cable
entry from the bottom to the inside.
Clean the cable hole.
NOTICE!
It is also possible to place the cable
entry on the back of the main clock.
For this effect:
a) Dismount the main clock in
reverse order from the wall.
( 1.1.1 Wall mounting).
b) Pierce a pre-cut hole from the
back to the inside.
c) Clean the cable hole. Insert the
cable according to the following
description.
d) Mount the main clock back on the
wall.
18
Ill. 5: Switchboard cut-out
Ill. 6a: pre-cut holes on the bottom
Ill. 6b: pre-cut holes on the back
V3.0 01/2011