System Setting Changes; Setting The Type Of Speakers; Parameters - Denon ADV-1000 Operating Instructions Manual

ENGLISH

(4) System setting changes

• The quick system settings and factory default settings are changed at the system setting change menu.
• The settings are stored in the memory until they are next changed, even when the power is turned off.

[1] Setting the type of speakers

• The composition of the signals output from the different channels and the frequency response are adjusted automatically according to the
combination of speakers actually being used.
1 At the SETUP MENU, select "SYSTEM SETUP" and press
the ENTER button
2
At the SYSTEM SETUP MENU screen, use the
cursor buttons to select the speaker system you are using.
"SPEAKER CONFIGURATION" and press the ENTER button.
> SETUP
SELECT :
Remote control unit
3 Set whether or not speakers are connected and, if so, their
size parameters.
Remote control unit
• The item to be set is displayed in yellow, and the values of the other
items are displayed in green.
S P E A K E R C O N F I G U R A T I O N
SELECT :
26
Downloaded From Disc-Player.com Denon Manuals
B
S Y S T E M S E T U P M E N U
S P E A K E R C O N F I G U R A T I O N S P E A K E R C O N F I G U R A T I O N
D E L A Y T I M E D E L A Y T I M E
C H A N N E L L E V E L C H A N N E L L E V E L
DVD AUTO DVD AUTO POWER POWER O F F O F F
SETUP MENU MENU
DEC I S ION: ENTER BUTTON
ENTER
Remote control unit
CENTER SPEAKER
FRONT SPEAKERS
SUB WOOFER
SURROUND
SPEAKEERS
B
F R O N T F R O N T S P . : S P . :
LARGE SMALL LARGE SMALL
CENTER CENTER S P . : S P . :
LARGE LARGE SMALL SMALL NONE NONE
SURROUND SURROUND S P . : S P . :
LARGE LARGE SMALL SMALL NONE NONE
SUBWOOFER SUBWOOFER : Y E S NO Y E S NO
SW SW F R E Q . F R E Q . : 8 0 H z 8 0 H z
LFE + + MAIN
SW MODE SW MODE : L F E L F E LFE MAIN
FINISH: ENTER BUTTON
4 Enter the setting.
• The Setup Menu reappears.
and
NOTE:
• Select "Large" or "Small" not according to the actual size of the
speaker but according to the speaker's capacity for playing low
frequency (approximately 100 Hz and below) signals. If you do
not know, try comparing the sound at both settings (setting the
volume to a level low enough so as not to damage the speakers)
to determine the proper setting.

Parameters

Large...... Select this when using speakers that can fully reproduce
low sounds of below 100 Hz.
Small...... Select this when using speakers that do not provide
sufficient volume for playing low frequencies of 100 Hz
and less. When this setting is made, frequencies below
the frequency set at the subwoofer frequency setting
are assigned to the subwoofer.
None...... Select this when no speakers are installed.
Yes/No.... Select "Yes" when a subwoofer is installed, "No" when
a subwoofer is not installed.
If the subwoofer has sufficient low frequency playback capacity,
good sound can be achieved even when "Small" is set for the
front, center and surround speakers.
For the majority of speaker system configurations, using the
SMALL setting for all five main speakers and Subwooofer On
with a connected subwoofer will yield the best results.
ENTER
Remote control unit