Replacing The Front Audio And Usb Assembly - Lenovo ThinkCentre M83 Hardware Maintenance Manual

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 234.

Replacing the front audio and USB assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 159.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 160
4. Locate the front audio and USB assembly. See "Locating major FRUs and CRUs" on page 80.
5. Press the retaining clip
same time.
Figure 187. Pivoting the drive bay assembly upward
6. Disconnect the front audio and USB assembly cables from the system board.
Chapter 9
1 in the direction as shown and pivot the drive bay assembly upward at the
.
Replacing FRUs (machine types: 10A2, 10A3, 10A8, 10A9, 10AH, 10AJ, 10AM, and 10AN)
215