Table of Contents
Advertisement
1 Disconnect the fixture from power: it must be off at least 10 seconds. Do not apply
power to the fixture until the uploader is connected and ready.
2 Connect the uploader to the fixture as you would a controller. Terminate the link.
3 Prepare the upload device for a boot mode upload but do not start the upload.
4 Apply power to the fixture. The control panel displays
When
5 Wait. The software has been installed when the fixture resets. Disconnect the
uploader.
To instal l software, backup method II
Use this procedure to install software only if all else fails.
1 Disconnect the fixture from the data link and power.
2 Use tweezers to move the jumper on PL107
on the main circuit board to the boot setting
as shown.
3 Prepare the upload device for a boot mode
upload but do not start the upload.
4 Connect the uploader to the fixture as you
would a controller. Terminate the link.
5 Apply power to the fixture and wait 5 seconds.
6 Start the upload. Wait. The software has been installed when the fixture resets.
7 Disconnect the fixture from power and move the jumper back to the normal setting.
b
is displayed, wait 5 seconds and then start the upload.
Basic service
CS E
, then
normal setting
b SL
b
, then
.
boot setting
37
Advertisement
Table of Contents
