Table of Contents
Advertisement
To test DMX control val ues
1 Program a set of commands for the fixture.
2 Scroll to tSt in the main menu, press [enter] and scroll to
3 Press [enter] to display the start code. The start code must be 0. Press [menu].
4 Scroll through the effects and press [enter] to display the DMX values received.
Compare the values with the DMX protocol.
U P L O A D M O D E
Software upload mode is normally engaged automatically. Use this option only if
automatic upload fails. See "Installing software" on page 36.
M A N U A L C O N T R O L
The manual control menu (
program and execute scenes as described under "Programmed Stand-alone" on page
26. The lamp strikes automatically when you enter the menu.
• To reset the fixture, select
• To turn the lamp on or off, select
See Table 7 on page 27 for additional options.
A D J U S T M E N T C O N T R O L
The adjustment menu (
A U T O M A T I C S T A N D - A L O N E C O N T R O L
The MiniMAC can be operated without a controller in Automatic Stand-alone
mode; see page 23.
) provides limited manual operation and is used to
Ct r
rS T
.
LO n
or
LOF
A dJ
) provides manual control for service use.
Control panel
LOg
. Press [enter].
.
19
Advertisement
Table of Contents
