Martin Professional MiniMAC Wash User Manual page 36

3 Rinse with distilled water. Mixing the water with a small amount of wetting agent such
as Kodak Photoflo will help prevent streaking and spotting.
4 Dry with a clean, soft and lint-free cloth or blow dry with compressed air.
To clean the fan and air vents
To maintain adequate cooling, dust must be cleaned from the fan and air vents
periodically.
• Remove dust and dirt from the fans and vent grills using a soft brush, cotton swab,
vacuum, or compressed air.
I N S T A L L I N G S O F T W A R E
Updates of the MiniMAC control software are released when features are added and
improved. The latest version is available for download from the Service and
Support area of the Martin Professional web site at http://www.martin.dk. Software
is installed using one of the following uploader devices:
• Martin MPBB1 with version 1.4 or later software
• Martin MP2
• Martin LightJockey 4064 DMX Interface with CPU version 1.1 or later
To install software, normal method
Important! The data link must be terminated as described on page 21.
1 Download the latest control software from the Martin Professional web site at
http://www.martin.dk. Install the software in the uploader.
2 Connect the uploader to the fixture as you would a controller. Apply power to the
uploader and the fixtures.
3 After the fixture has finished resetting, start the upload as described in the uploader
documentation. Wait. The software has been installed when the fixture resets.
Disconnect the uploader.
4 If a check-sum error (
interrupted or corrupted during transmission. Reattempt the upload using backup
method I.
To install software, backup method I
Follow this procedure exactly as described to install software if a normal upload
attempt is unsuccessful and a check-sum error (
36
CS E
) occurs and/or the fixture does not reset, data was
Basic service
C SE ) occurs.