Table of Contents
Advertisement
G
OBOS
The MiniMAC Profile accepts glass and metal gobos with the following
dimensions:
Outside diameter. . . . . . . . . . . . . . . . . . . . . 22.5 mm + 0/- 0.3 mm (0.886 in. +0/- 0.012 in)
Maximum image diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 mm (0.669 in)
Maximum thickness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.8 mm (0.071 in)
The positions of the standard gobos, as seen
from front, are shown to right and the correct
orientation for different gobo types is shown
below. When in doubt, install gobos with the
more reflective side towards the lamp.
To change gobos
1 Turn off the lamp and allow it to cool for at least
5 minutes. Disconnect the fixture from power.
2 Unlock the head cover fasteners by turning
them a quarter-turn counterclockwise. Pry open the lamp access cover from the
ribbed end and remove the head cover.
3 Tilt the head up. Turn the gobo wheel as required to
access the gobo. Squeeze the ends of the gobo spring
together and remove it. Tilt the head down and catch the
gobo as it falls out.
4 Tilt the head back up and drop the replacement gobo in
the holder. Squeeze the spring together and carefully
place it over the gobo.
To focus gobos
•
Project a gobo on a surface 2 meters or more away from the fixture. Turn the front
lens as required to focus the pattern.
32
Gobos
9
Advertisement
Table of Contents
