Cleaning The Sensor/Charging Terminal - LG VR59xxL series Owner's Manual

CLEANING THE SENSOR/CHARGING TERMINAL

There are sensors on the Roboking that can detect obstacles, stairways and
the home station for charging the battery. In order to maintain the performance
of the Roboking, regularly clean the sensors and charging terminal as follows:
1. Lay a smooth cloth on the floor, overturn the Roboking and put it on the
cloth.
2. Turn off the power switch on the bottom of the Roboking. Injury can be
caused by the activation of the Roboking if the main power is not turned off.
3. Use a smooth cloth or cleaning brush to wipe the dust off each sensor and
the charging terminal as described below.
Receiving sensor of
remote controller
Camera sensor
Tip
ot clean the Roboking by directly spraying it with water, thinner, benzene, etc.
Call the service center if the sensors or charging terminals are damaged. Sensor and terminal
damage can cause the product to malfunction.
Charging terminal
Obstacle detection sensor
Cliff detection sensor
Charging terminal
Lens
24