Table of Contents
Advertisement
7)
Turn on the power supply to the recorder,
and check the LED display. The Power LED
should light up immediately.
8)
After an interval of approximately one
minute, when the recorder has successfully
started up and completed its self-test, the
second LED (marked with a heart symbol)
will begin to flash. This shows that the
recorder is working properly. If this LED d
not light up, or remains permanently on or
off, there is a problem with the recorder.
9)
Once the Power LED is lit, and the
'heartbeat' LED is pulsing, fit the connector
cover using the two screws supplied (see
Fig. 2.4)). Installation is complete.
2.5 D
ISCONNECTING THE RECORDER
You must shut down the recorder if you need to disconnect it or move it to a new location. Doing this
will ensure that the drive is not damaged during the move, and no data is lost. Take care not to shut
down the recorder by accident – nothing will be recorded while the disk is shut down.
To shut down the recorder:
1)
Enter the menu system using the MENU key.
2)
In the main menu, use
In the Recorder menu, use
3)
In the Recorder Advanced menu, use
4)
to the next screen.
to go to Shut Down Recorder and then press
5)
Use
A message appears saying Recording will be disabled until the recorder is
6)
reset. Are you sure?
The default response is No: use
7)
Recorder disabled appears on screen, followed by Recorder Disconnected. At the top
right you will then see the message Shutting off the recorder followed by You can now
turn off your recorder. At this point you can now remove power from the recorder and
disconnect it from the camera.
2.6 C
ONFIGURING THE RECORDER
To configure the recorder for continuous, event, or scheduled recording please refer to the camera
manual (section 6.2).
2.7 V
ERSIONS
To check version numbers for the recorder, please refer to the camera manual (section 6.4).
Recorder Installation Manual v3.14
oes
to go to Recorder and then press
to go to Advanced and then press
to go to Disk Operations and then press
to choose Yes, then press ENTER to confirm. The message
Fig. 2.4) Fitting the connector cover
to go to the next screen.
to go to the next screen.
to go to the next screen.
to go
Page 11
Advertisement
Table of Contents
