Maintenance and Adjustment
Coolant Level Adjustment
Warning
Do not remove the expansion tank cap or
radiator pressure cap when the engine is
hot. When the engine is hot, the coolant
inside the radiator will be hot and also
under pressure. Contact with this hot,
pressurised coolant will cause scalds and
skin damage.
Allow the engine to cool.
1
f
1.
Final drive belt cover
2. Final drive belt cover screws
Remove the final drive belt cover as follows:
Release the four screws from the cover and
remove.
Remove the cap from the expansion tank,
and add coolant mixture through the filler
opening until the level reaches the MAX
mark. Refit the cap.
76
Note:
•
If the coolant level is being checked
because the coolant has overheated,
also check the level in the radiator
and top up if necessary.
•
In an emergency, distilled water can
be added to the cooling system.
However, the coolant must then be
drained and replenished with H4DX
Hybrid OAT coolant as soon as
possible.
2
If hard water is used in the cooling system,
it will cause scale accumulation in the
engine and radiator and considerably
reduce the efficiency of the cooling system.
Reduced cooling system efficiency may
cause the engine to overheat and suffer
severe damage.
Refit the final drive belt cover as follows:
Align the cover to the crankcase. Fit and
tighten the four screws to 9 Nm.
Coolant Change
2
Have the coolant changed by an authorised
Triumph dealer in accordance with scheduled
maintenance requirements.
Caution
Need help?
Do you have a question about the Thunderbird Commander and is the answer not in the manual?