Right Handlebar Switches; Engine Stop Switch; Starter Button; Scroll Button - Triumph Thunderbird Commander Handbook

Right Handlebar Switches

1
5
cfcc
1.

Engine stop switch

2. STOP position
3. RUN position

4. Starter button

5. Scroll button

Engine Stop Switch
In addition to the ignition switch being turned
to the ON position, the engine stop switch
must be in the RUN position for the
motorcycle to operate.
The engine stop switch is for emergency use.
If an emergency arises which requires the
engine to be stopped, move the engine stop
switch to the STOP position.
Note:
• Although the engine stop switch
stops the engine, it does not turn off
all the electrical circuits and may
cause difficulty in restarting the
engine due to a discharged battery.
Ordinarily, only the ignition switch
should be used to stop the engine.
General Information
Do not leave the ignition switch in the ON
position unless the engine is running as
2
this may cause damage to electrical
components and will discharge the battery.
3
Starter Button
The starter button operates the electric
starter. For the starter to operate, the clutch
lever must be pulled to the handlebar.
Note:
• Even if the clutch lever is pulled to
4
the handlebar, the starter will not
operate if the side stand is down and
a gear is engaged.
Scroll Button
The scroll button is used to operate the
following functions of the instruments:
• Odometer functions (see page 24)
• Trip reset (see page 24)
• Clock reset (see page 25).
Caution
33