Figure 10-2 Edit Ip Static Route - ZyXEL Communications ZyWall 10 User Manual

Zyxel zywall internet security gateway

Hide thumbs Also See for ZyWall 10:

Table of Contents

ZyWALL 10~100 Series Internet Security Gateway

This field shows whether this static route is active (Yes) or not (No).

This parameter specifies the IP network address of the final destination. Routing is

always based on network number.

This is the IP address of the gateway. The gateway is an immediate neighbor of your

ZyWALL that will forward the packet to the destination. On the LAN, the gateway must

be a router on the same segment as your ZyWALL; over the WAN, the gateway must

be the IP address of one of the remote nodes.

Click a static route index number and then click Edit to set up a static route on the

10.2.1 Configuring Route Entry

Select a static route index number and click Edit. The screen shown next appears. Fill in the required

information for each static route.

The following table describes the fields in this screen.

Table 10-1 IP Static Route Summary

Figure 10-2 Edit IP Static Route

Static Route