LABEL
Allow From WAN
to DMZ
Allow Trigger Dial
Apply
Reset
8.6
Configuring WAN MAC
To change your ZyWALL's WAN MAC settings, click WAN, then the WAN MAC tab. The screen appears
as shown.
The MAC address screen allows users to configure the WAN port's MAC Address by either using the factory
default or cloning the MAC address from a computer on your LAN. Choose Factory Default to select the
factory assigned default MAC Address.
Otherwise, click Spoof this computer's MAC address - IP Address and enter the IP address of the
computer on the LAN whose MAC you are cloning. Once it is successfully configured, the address will be
copied to the rom file (ZyNOS configuration file). It will not change unless you change the setting or upload
a different ROM file.
WAN Screens
Table 8-6 IP Setup
Select this option to forward NetBIOS packets from the WAN port to the DMZ port.
(Not all ZyWALL models have a DMZ port.)
Select this option to allow NetBIOS packets to initiate calls.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Figure 8-7 MAC Setup
ZyWALL 10~100 Series Internet Security Gateway
DESCRIPTION
8-13