LABEL
Drop DTR When
Select this check box to have the ZyWALL drop the DTR (Data
Hang Up
Terminal Ready) signal after the "AT Command String: Drop" is sent
out.
AT Response
Strings
CLID
Type the keyword that precedes the CLID (Calling Line Identification)
in the AT response string. This lets the ZyWALL capture the CLID in
the AT response string that comes from the WAN device. CLID is
required for CLID authentication.
Called ID
Type the keyword preceding the dialed number.
Speed
Type the keyword preceding the connection speed.
Call Control
Dial Timeout
Type a number of seconds for the ZyWALL to try to set up an
(sec)
outgoing call before timing out (stopping).
Retry Count
Type a number of times for the ZyWALL to retry a busy or no-answer
phone number before blacklisting the number.
Retry Interval
Type a number of seconds for the ZyWALL to wait before trying
(sec)
another call after a call has failed. This applies before a phone
number is blacklisted.
Drop Timeout
Type the number of seconds for the ZyWALL to wait before dropping
(sec)
the DTR signal if it does not receive a positive disconnect
confirmation.
Call Back Delay
Type a number of seconds for the ZyWALL to wait between dropping
(sec)
a callback request call and dialing the corresponding callback call.
Apply
Click Apply to save your changes back to the ZyWALL.
Reset
Click Reset to begin configuring this screen afresh.
WAN Screens
ZyWALL 10~100 Series Internet Security Gateway
Table 8-9 Advanced Setup
DESCRIPTION
EXAMPLE
NMBR
CONNECT
60
0
10
20
15
8-23