VSG-1200 User's Guide
Note: You must restart the VSG if you change the IP address.
If you set the VSG as a DHCP server on the LAN, the VSG will automatically
change the LAN DHCP settings based on the new LAN IP address.
4.7 WAN Configuration
To configure the WAN settings on the VSG, click System Settings and WAN/LAN. The
WAN/LAN screen varies depending on the settings in the WAN Port Mode field.
4.7.1 Configuring WAN MAC Address
Use the WAN/LAN screen to configure the MAC address of the WAN port by either setting
the VSG to use the factory default or specify the MAC address of a computer on the LAN.
Figure 19 System Settings: WAN/LAN: WAN MAC Address
The following table describes the related field in this screen.
Table 6 System Settings: WAN/LAN: WAN MAC Address
FIELD
WAN MAC Address
4.7.2 WAN IP Address Settings
Use the WAN/LAN screen to change the WAN IP address settings.
54
DESCRIPTION
Select Default to use the factory assigned MAC address.
If your ISP requires MAC address authentication, select Change to and enter
the MAC address of a computer on the LAN in the fields provided.
Chapter 4 LAN, WAN and Server Setup