ROBBE ARCUS SONIC RTF Operating Instructions Manual page 8

Using the charger to charge the flight battery
The battery charger must be connected to a 12 V power
source with a minimum output power of 2 A using the con-
necting lead supplied. Correct polarity is essential.
The red monitor LED on the charger lights up. Connect the
battery to the charger.
During the charge process the green monitor LED on the
charger flashes. When the charge process is complete,
you will hear an audible signal, and the green monitor LED
on the charger glows constantly.
Disconnect the battery from the charger as soon as it is
fully charged, and disconnect the power source from the
power supply.
Safety Notes
Do not operate your charger and batteries on an inflam-
mable surface, and do not leave the equipment running
unsupervised. Protect from damp. Do not subject to direct
sunshine, and do not cover the charger.
Do not charge batteries that are hot to the touch. Allow
batteries to cool down to ambient temperature. Charge the
battery only using the charger included in the set; do not
use any other charger. The charger should only be used to
charge the battery included in the set.
8
Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565
Safety Notes regarding LiPo batteries:
• Do not place the battery in water or any other liquid.
• Do not heat or incinerate the battery; do not place it
in a microwave oven.
• Avoid short-circuits, and never charge the battery with
reversed polarity
• Do not subject the battery to pressure or shock loads, and
never distort or throw the pack.
• Never solder directly to the battery
• Do not modify or open the battery
• Batteries must only be charged with a suitable charger;
never connect the battery directly to a mains power supply.
• Never charge or discharge a battery in bright
sunlight, or close to a heater or open fire.
• Do not use the battery in areas subject to
high levels of static discharge.
• Any of these errors can result in damage to the battery,
explosion or even fire.
• Keep the battery out of the reach of children
• Do not allow escaped electrolyte to come into contact
with fire, as it is highly inflammable, and may ignite.
• Avoid the fluid electrolyte contacting the eyes.
If this should happen, flush with copious amounts of clean
water and contact a doctor without delay.
• The fluid electrolyte can also be removed from clothing
and other objects by rinsing in plenty of water.
LIABILITY EXCLUSION
Since robbe Modellsport is not in a position to monitor the
handling of these batteries, we expressly deny all liability and
guarantee claims where the batteries have been incorrectly
charged, discharged or handled.