Manitowoc QuietQube Indigo Series Technician's Handbook page 207

3. Cut the tubing of the defective component with a
small tubing cutter.
4. Solder the replacement component in place.
Allow the solder joint to cool.
5. Remove the pinch-off tool.
6. Re-round the tubing. Position the flattened tubing
in the proper hole in the pinch-off tool. Tighten the
wing nuts until the block is tight and the tubing is
rounded.
The pressure controls will operate normally
NOTE:
once the tubing is re-rounded. Tubing may not re-
round 100%.
Part Number STH026 8/12
USING PINCH-OFF TOOL
207