Installing Drive Bell - Maytag NAV2330 Service Manual

Disassembly Procedures
!
WARNING
3. Using care pry drive bell upward off transmission
shaft.
4. Remove old seal from hub assembly by:
a. Placing a flat bladed screwdriver between bottom
edge of seal and hub.
b. Using washtub bolts as a pry area, pop off lower
seal bead.
c. Grasping bottom of seal and pulling straight up
freeing upper seal bead.
Hex
nut
Hub
assembly
Hub
shoulder
5. Clean all foreign material from seal mounting area of
hub assembly, bronze bearing and washer.
6. Lubricate new seal with liquid soap or soapy water to
aid in assembly of seal onto hub.
7. Apply a small amount of supplied grease,
No. 36765P, to inside sealing lips of seal.
Apply grease to
inside sealing lips
Hub
assembly
NOTE: DO NOT allow any lubricants to come in contact
with outside surface of seal.
8. Apply remainder of supplied grease, No. 36765P, to
exposed surface of washer between transmission
output shaft and seal.
9. Place new drive bell seal onto hub and push into
position using large end of No. 293P4 Seal Tool.
24
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
NOTE: Using a small pocket mirror, check entire
10. Turn No. 293P4 Seal Tool upside-down and place the
small end over transmission output shaft and onto the
seal.
11. Push down on tool with a quick motion until it
bottoms out and the top of seal is fully seated.
Transmission
output shaft
Washer
293P4
Bronze
Seal tool
bearing
Hub
assembly
Transmission
output shaft

Installing Drive Bell

Seal
1. Position new drive bell over transmission output shaft.
Rotate drive bell until splines in drive bell line up with
splines on transmission output shaft.
2. Screw
bottoms out.
3. Using a wrench or socket, tighten bolt CLOCKWISE
to force drive bell down onto transmission shaft until
drive bell bottoms out on shaft.
NOTE: Tighten new shoulder screw between 60 to 80
4. Place new plug over hole in drive bell and firmly press
into place using the palm of your hand.
NOTE: It may be necessary to insert the end of a paper
16022937 Rev. 0
circumference of bottom seal flange to verify seal
is pressed down against shoulder on hub; there
should be no gap!
Hub
assembly
Hub
shoulder
Bottom
seal flange
7
/ " bolt into transmission output shaft until it
16
inch-pounds.
clip or thin blade screwdriver along side of plug
as it is pressed into drive bell to release
entrapped air.
293P4
Seal tool
Top of
seal
Apply
36765P
grease
©2005 Maytag Services