Agitator; Door Switch; Drive Bell And Seal Assembly Style Units - Maytag NAV2330 Service Manual

Disassembly Procedures
!

Agitator

1. Open loading door.
2. Remove fabric softener dispenser by unsnapping from
agitator. Remove agitator by one of two ways.
a. (Auger style agitators) Loosen bolt in
agitator and remove by sliding straight
up output shaft of transmission.
b. (Flex vane agitators) Remove flex vane
agitator by placing hands under agitator
lip and pull upward. If agitator is difficult
to remove, use two agitator removal
hooks, No. 254PRP under bottom edge
of agitator. Remove drive bell by pulling
upward. If drive bell is difficult to remove,
use agitator hooks.
a.
a.
©2005 Maytag Services
WARNING
16022937 Rev. 0
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
b.
NOTE: Hooks must be positioned 180° from each other,
and must be placed under base of agitator near
agitator vane for greater stability. If hooks are
placed between the vane area, agitator damage
may occur.
3. Using a rocking motion (side-to-side) carefully lift
agitator up off drive bell.
4. To reassemble place agitator on top of drive bell.
Slowly rotate agitator until fingers on underside of
agitator line up with large slots on drive bell.
5. A sharp blow on top of agitator, with the palm of your
hand, will force agitator down onto drive bell, allowing
fingers on underside of agitator to lock under bottom
edge of drive bell.
NOTE: Do not push agitator onto drive bell any further
than necessary.

Door Switch

1. Remove front panel, see "Front Panel" procedure.
2. Remove screws securing cabinet top.
3. Tape loading door closed and lift cabinet top to a
vertical position by hinging it on the rear hinges.
NOTE: Cabinet top is self supporting, a small chain may
be used for additional support.
4. Disconnect wires from door switch.
5. Remove screw securing door switch assembly to
underside of cabinet top.
NOTE: See appropriate wiring diagram when rewiring
components.
6. Remove screws securing switch to switch holder.
7. Remove switch from switch holder.
8. Reverse procedure to reassemble.

Drive Bell and Seal Assembly Style Units

NOTE: If water is present in washtub, remove water
before attempting to remove drive bell.
1. Remove agitator, see "Agitator" procedure.
7
2. Remove plug and / " bolt from top of drive bell.
16
Agitator
hooks
23