Motor And Mounting Bracket; Pump And Belt Removal - Maytag NAV2330 Service Manual

Disassembly Procedures
!
WARNING
Seal Nut (seal grease 056016.)
17. Install new bearing using Brake/Bearing tool
12002012, large washers and PVC end cap.
Important: Use large washers to prevent damage
to bearing.
18. Reassemble washer.

Motor and Mounting Bracket

1. Remove service access panel, see "Service Access
Panel" procedure.
NOTE: There will always be some water that will remain
in outer tub, before removing hoses from pump,
hoses must be pinched off or drained to prevent
water spillage.
2. Loosen hose clamps and remove hoses from pump
assembly.
3. Unhook idler spring from clip on front of the motor
mounting bracket.
NOTE: Use care when releasing idler lever tension. If
idler spring is overstretched, washer operation
will be affected.
4. Reach in and around left side of motor and remove
belt off large drive pulley.
©2005 Maytag Services
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
5. Disconnect wire harness from motor switch by
pressing down on locking tab on top of connection
block and at the same time, pull connection block
away from motor switch.
Locking
tab
Connecting
block
6. Remove bolts securing motor and mounting bracket to
lower outer tub flange and to weldment assembly.
Idler
spring
7. Lift complete assembly out of washer.
NOTE: Lay motor on its side. Observe belt configuration
around rear pump leg. Belt MUST encircle rear
pump leg when reassembling.
8. Reverse procedure to reassemble.

Pump and Belt Removal

1. Remove motor, see "Motor and Mounting Bracket"
procedure.
2. Remove screws securing pump assembly to motor.
16022937 Rev. 0
Switch attaching screws
Motor mounting
attaching screws
Motor
switch
Belt
Pump
hoses
27