Installation Requirements - Maytag NAV2330 Service Manual

Installation Requirements

Consider
Location
Electrical Requirements
Water Supply Faucets
Water Pressure
Drain
Part No. 40085801
Printed in U.S.A. 8/99
©2005Maytag Services
Description
Use dimensions shown in manual to determine space needed for easy
installation and servicing.
Install washer on a solid floor. Never install washer on a platform or weak
support structure.
Wood floor constructions may sometimes need to be reinforced to minimize
vibration from unbalanced loads.
DO NOT install washer on carpeted floor. Carpet and soft tile surfaces also
contribute to vibration and/or tendency for washer to move slightly during spin
cycle.
Washer requires 120 volt, 15 amp, 60 Hz power supply and 3-prong grounding
plug. Power cord is approximately 69" long. Refer to serial plate for specific
requirements. Wiring diagram is located in control hood.
Water supply faucets must fit standard
couplings. Do not use slip-on or clamp-on connections.
NOTE: Water supply faucets should be easily accessible and turned off before
extended periods of non-use.
Static pressure measured at faucet must be 20–120 pounds per square inch
(138 to 827 kPa). Water pressure under 20 pounds per square inch (138 kPa)
results in extended washer fill time.
Drain receptacle must be able to handle hose with at least 1¼" (32cm) outside
diameter. End of drain hose must be 36" (91.44 cm) above floor, or water may
run out of washer before end of cycle.
16022937 Rev. 0
Before You Install
3
/ " (19.05 mm) female garden hose
4
© 1999 Amana Appliances
Amana, Iowa 52204
A7