Complete Installation; Installing Coin Slide And Coin Box - Maytag MAT23CS Instructions Manual

Connect Inlet Hoses to Washer
1. Attach cold water hose to cold water inlet valve marked with
a blue ring. Screw coupling by hand until it is snug.
2. Attach hot water hose to hot water inlet valve marked with
a red ring. Screw coupling by hand until it is snug.
3. Use pliers to tighten couplings an additional two-thirds turn.
NOTE: Do not overtighten. Damage to the valve can result.
4. Turn on water faucets to check for leaks. A small amount
of water may enter washer. It will drain later.
NOTE: Replace inlet hoses after five years of use to reduce
the risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.

COMPLETE INSTALLATION

WARNING
Electrical Shock Hazard
Electrically ground this appliance.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Check electrical requirements. Be sure that you have the
n
correct electrical supply and the recommended earthing
method.
Check that all parts are now installed. If there is an extra part,
n
go back through steps to see what was skipped.
Check that you have all of your tools.
n
Check that shipping materials were completely removed
n
from washer.
Dispose of/recycle all packaging materials.
n
Check that the water faucets are on.
n
Check for leaks around faucets and inlet hoses.
n
Remove film from console and any tape remaining on
n
washer.
Plug into an earthed outlet or connect power.
n
Check that circuit breaker is not tripped or fuse is not blown.
n
Start washer using the payment system (if available) to
n
check that the wash cycle completes without an error code
or water leak.
INSTALLING COIN SLIDE AND
COIN BOX
The coin slide mechanism, service door lock and key, and coin
box lock and key are not included with some models but can
be obtained from the usual industry sources. The coin slide
(W10813856) supplied by Greenwald was used for testing and
evaluation purposes. If a different supplier is used, ensure that
the switch is D41 or a similarly qualified switch construction.
Alternative constructions require review by
a Whirlpool codes engineer.
Remove the service door of the
meter case by lifting it up at the
back. Install the money-accepting
device. (Refer to manufacturer's
instructions for proper installation.)
Extra wire should be coiled and
tie-wrapped to the mounting hole
inside the meter case.
An earthing connection is needed
for the coin slide, which can be
made by connecting the available
harness (W10846503) to the coin
slide. The provided earthing clip is
designed for 0.89–1.27 mm material
thickness.
15