Networking Your Printer; Connecting To A Wireless Network; Before You Connect; Connecting To A Wireless Network Using The Wifi Setup Wizard - Kodak ESP 5200 Extended User Manual

2

Networking Your Printer

Connecting to a wireless network

Before you connect

Connecting to a wireless network using the WiFi Setup Wizard

Connecting to a non-WPS wireless router
This section explains how to configure or change your network settings.
To connect your printer to an 802.11b/g wireless (Wi-Fi) network, refer to the
following information.
You need:
• a wireless router.
• to determine whether your wireless router supports Wi-Fi Protected Setup
(WPS).
NOTE: If you have specific questions about your router, see your router
manufacturer's documentation for more information.
You can use the WiFi Setup Wizard on the printer to connect to your wireless
network. Use the procedure that is appropriate for your network setup.
To connect your printer to your wireless network, you need to know the network
name, also called the Service Set Identifier (SSID). You can obtain your network
name from the wireless router.
If your network has security enabled, you also need to know the password
(passphrase or security string).
Record your network information in the spaces below, using the correct uppercase
and lowercase letters.
Network Name (SSID):_____________________________________________________
Security String: ___________________________________________________________
1. Press Home.
2. Press to select Network Settings, then press OK.
3. With WiFi Setup Wizard selected, press OK.
NOTE: The Wi-Fi radio turns on when you select Wi-Fi Setup Wizard.
www.kodak.com/go/aiosupport 5